View Cart

Misc. Equipment

« Return to Product Categories

Bottling Spigot 3/8"


Fits a drilled 6.5 gallon pail. Requires a 1" diameter hole for installation. Rubber gasket goes on the outside of the bucket for a positive seal - don't overtighten. Use with 3/8" I.D. tubing.

Temporarily out of stock

Dual Threaded insert for Wooden tap Handle


Create a taphandle of your very own and mount it with this easy to use threaded insert. Simply drill a 1/2" hole in the bottom of your wooden piece and thread the D1299 with a 3/8", 16 thread-per-inch bolt with a nut attached (a coin can also be used). When you are finished, remove the bolt and mount your new taphandle to your faucet!

Add to Cart

Fermzilla Carbonation Cap


This carbonation cap is made out of plastic and is the same as the ones found in the FermZilla Pressure Kit. It is a screw-on cap with an integrated Cornelius ball lock fitting. The design is in place to fit most soft drink PET bottles.

The carbonation cap is a highly effective method to add and maintain carbonation in beverages for extended periods of time. Made from plastic, this carbonation cap will last years of use with virtually no maintenance.

With the cap, you can simply fill any old PET bottle with cold liquid of your choice and carbonate by connecting a ball lock disconnect.

Add to Cart

Hanger Bolt for Tap Handle


This is a dual sided screw, one that goes into the D1298 and the other is a wood screw for going into a wood tap handle. 5/16 - 18 thread, total length ranges from 1.5 inches to 1.75 inches

Add to Cart

Latch top Bottle gasket


These Grolsch style Gaskets are a standard size and will fit either the 32 ounce or the 16 ounce EZ Cap bottles. Each gasket should last at least 5 or 6 uses

Add to Cart

« Return to Product Categories